To ensure the safety of production, the barite mill will have abnormal noise in any part, or the load will suddenly increase and stop immediately to check and eliminate the fault to avoid major accidents. When you continue to turn on the machine, you must take out the remaining material in the mill. Otherwise, the current will be too large when starting up, which will affect the startup.

When shutting down, the machines should be shut down in the following order:

• 1. Close the feeder to stop feeding;


• 2. Stop the host after about one minute;


• 3. Stop the blower after blowing off the residual powder;


• 4. Turn off the analyzer afterwards.
  The order of shutdown is: feeder → host → blower → analyzer.
  Note: After the hoist transports the material to the silo for a certain amount, the crusher is stopped first and then the lift is stopped. This should be changed by the stock amount.


• 5. The grinding machine is not allowed to refuel at any time during normal work.